Search Results
Filter Your Search
Shop by Category
These seals are specifically designed with a second lip on their inside diameter and engineered to attain maximum, life and reliability in dynamic rod sealing. This feature results in reduced leakage, less friction, increased stability, and, prevents air and contaminants from entering the cylinder.
92A Durometer | Urethane Material | 3 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
Features
- General purpose rod seal
- Robust design
- Excellent wear resistance
- Increase seal stability
- Performs well over wide temperature range and is extremely effective in low temperatures
- Primary lip protection
- Easy to install
This wiper is a single lip design molded from high grade nitrile and bonded to a carbon steel case.
Nitrile Material | 40 MM Nominal Inner Diameter | Wiper
MHT-60X70 has a wall thickness of 5 mm. The ID is 60 mm and the OD is 70 mm. The material is 1026 Carbon Steel and has been stress-relieved and annealed.
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
1-14 | $6.41 |
15-74 | $4.97 |
75-104 | $4.48 |
105+ | $4.08 |
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 50 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
Style 850 u-seals offer excellent resistance to extrusion and abrasion. The round cross-section expander offers energized sealing from zero to 5,000 psi.
95A Durometer | Urethane Material | 5 1/2 in Nominal Inner Diameter | 7/32 in Cross Section | U-Seal
Piston diameter “I” dimensions are given for pistons without wear rings.
15% Glass Filled PTFE Material | 2.223 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Molded from 93 Shore A polyurethane with a 70 Shore A energizer, this seal utilizes the same groove dimensions as a standard o-ring or T-seal. One or two Style 575 back-up rings may be used for wider grooves. Extrusion resistant by design, this seal is also resistant to rolling and twisting. Installation is an easy two step snap-in procedure with no need to re-size before insertion into the bore. Piston diameter “I” dimensions are given for pistons without wear rings.
93A; 70A Durometer | Urethane Material | 3 1/8 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
These piston seals provide bi-directional, low friction sealing with increased stability and superior leakage control. The square cut energizer provides low pressure sealing and eliminates backside leakage. This seal also effectively seals between different fluids on each side of the piston seal, making gas/liquid sealing combinations possible. Piston diameter “I” dimensions are given for pistons without wear rings.
40% Bronze Filled PTFE Material | 1.384 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
1.375 X 1.688 X 0.219 Twin Lip URE
Molded in PTFE with a rubber energizer, this seal absorbs the shock of pressure spikes to protect the rod seal. Bronze-filled Teflon rod buffer seal with a rubber energizer.
Bronze Filled PTFE Material | 2 1/2 in Nominal Inner Diameter | Buffer Seal