Search Results
Filter Your Search
Category Group
Shop by Category
Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.
Nylon Material | 1 3/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring
Features
- Protection Against Wear
- Reduced Friction
- Extended Cylinder Life
- Operational Efficiency
The Hallite 533 is capable of withstanding high side loads and preventing metal-to-metal contact between the piston and the bore or the rod and the gland.
The PA 533 material is heat stabilised 33% glass reinforced nylon 66, which offers excellent bearing properties.
Compatible with hydraulic and lubricating oils. The PA 533 material is not recommended for use in water based fluids (HFA) or where significant water is present, due to the swell of the nylon.
A heavy duty double-acting assembly, the capped piston T-seal exhibits excellent sealability, extrusion resistance, and wearability. T-seals with “BR” suffix utilize a Bronze Filled PTFE cap instead of the standard Glass Filled PTFE cap.
PTFE; Nylon; Rubber Material | 7.274 in Nominal Inner Diameter | Capped Piston T-Seal
Features
- Glass-filled PTFE cap, nylon back-up, rubber energizer
DE-13 is a standard rod eye machined from Cast Iron.
A rod eye is a type of mount attached to the end of the cylinder rod. This connects to a mounting point on the machine and usually incorporates a bearing to allow for some movement.
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 50 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
The PS1400 seals offer low friction and high strength in a compact double-acting piston seal design. The PTFE seal ring, combined with a rubber energizer, assures positive contact with the dynamic surface. The PS1400 is designed to fit ANSI/B93.32-1973 groove standards. Piston diameter “I” dimensions are given for pistons without wear rings.
15% Glass Filled PTFE Material | 1.24 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Grade 8 nylon insert lock nut. The thread size is
1.25 in – 12 UNF and the nominal hex is
2 in.
Grade 8 lock nuts have a nylon insert in the nut that allows the nut to grab the fastener. This keeps the nut from backing off due to vibration.
Molded from a PTFE base material with 40% bronze and machined to exacting tolerances, this seal exhibits low friction and high strength corners are chamfered for cold flow resistance.
40% Bronze Filled PTFE Material | 3 3/8 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
