Wipers
Filter Your Search
Shop by Category
Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.
Nitrile Material | 50 MM Inner Diameter | Wiper
Each Seal Guard Wiper consists of two flexible bronze rings which are held in place by a nitrile cushion ring. The cushion ring absorbs side loads and energizes the wiper to maintain close contact with the rod. Particularly suited for hostile environments, seal guard wipers shave off sand, grift, slag, flux, paint, moisture, chips and slivers. Seal Guard Wipers are long-lasting, self-adjusting, and offer low friction. Seal Guard Wipers can be installed in standard Hercules® Sealing Products “ST” or “D” Style grooves by increasing the “F” gland dimension to the “F” Throat Diameter shown.
70A Durometer | 660 Bronze; Nitrile Material | 2 1/2 in Nominal Inner Diameter | Wiper
Medium Duty Buna Wiper with a crush lip providing interference in the groove helping to eliminate contaminants entering through the groove.
Buna-N Material | 1 in Inner Diameter | Wiper
Wipers are installed in hydraulic cylinders to prevent dirt, dust, and moisture from entering the cylinder as they retract back into the system. A hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components.
90A Durometer | Urethane Material | 5 in Nominal Inner Diameter
Features
- Installed in hydraulic cylinders to prevent dirt, dust, and moistures
- Hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components
Wipers are installed in hydraulic cylinders to prevent dirt, dust, and moisture from entering the cylinder as they retract back into the system. A hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components.
90A Durometer | Urethane Material | 5 1/2 in Nominal Inner Diameter
Features
- Installed in hydraulic cylinders to prevent dirt, dust, and moistures
- Hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components
MRW, 70mm Brass Cad Plated Rod Wiper
Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.
90A Durometer | Urethane Material | 5/8 in Nominal Inner Diameter
Features
- Slotted heel design
- Slots in the heel allow excess hydraulic fluid to bypass the wiper
Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.
90A Durometer | Carboxilated Nitrile Material | 1 1/4 in Nominal Inner Diameter
Features
- Slotted heel design
- Slots in the heel allow excess hydraulic fluid to bypass the wiper
Style AN-M2 scrapers conform to MS28776-M2 sizes and are manufactured in brass. The scrapers are suitable for extreme environments with aggressive contaminants. The unique spring-loaded construction and ductile material result in close rod contact even when coping with rod ovality and helix grinding patterns.
Brass Material | 2 1/2 in Nominal Inner Diameter
Features
- Scrapers are suitable for extreme environments with aggressive contaminants
- Unique spring-loaded construction
- Manufactured in brass
AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.
AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.
- Flexible, snap-in design for easy installation into closed housings
- Low compression set