Search Results

SBMM70ES-2RS has a 70 mm ID.

The bushing is Sealed and made of forged steel. The ball will swivel like a fish eye with 3-5 degrees of movement.

UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.

90A Durometer | Urethane Material | 5 3/8 in Nominal Inner Diameter | 5/16 in Cross Section | U-Seal

The Z-Seal™ is a squeeze type seal, combining the excellent sealability and low compression set of a resilient rubber lip with the greater anti-extrusion characteristics of a hard thermoplastic base. Under low pressure conditions, the sealing lip provides its own compressive seal force. As pressure increases, hydrostatic pressure is mechanically transmitted through the elastomeric seal element into the anti-extrusion base. The applied force then deflects radially in a controlled manner, closing the extrusion gap behind the sealing lip. Under this condition, maximum sealing effectiveness is achieved.

95A 70A Durometer | Urethane Nitrile Rubber Material | 1 3/4 in Nominal Inner Diameter | 3/16 in Cross Section | Z-Seal

US-URE/NBR-2×2-3/8×3/8

Solid Teflon backup ring with a flat cross-section.

PTFE can withstand high temperatures and is compatible with nearly all fluids.

PTFE Material | 4 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation
• Deals very well with surface wear

CPLUG-NYL-1-1/4BLT PL(10)

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 1 1/2 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

3 5/8 X 4 Back-up SOLID PTFE

Solid Urethane backup ring with a flat cross-section.

95A Durometer | Urethane Material | 3 3/4 in Nominal Inner Diameter | 3/16 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation

Solid Urethane backup ring with a flat cross-section.

95A Durometer | Urethane Material | 5 1/8 in Nominal Inner Diameter | 3/16 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation