Search Results

Our vee sets are the finest quality available in the industry. While all sets incorporate fabric reinforced rubber pressure rings, one or two urethane rings are included to improve low pressure sealing, when it is feasible. Most sets use nylon adaptors.

Fabric Reinforced Rubber Material | 4 in Nominal Inner Diameter | Packing Set

Features

• Use nylon adaptors
• Low pressure sealing

WR-NYL, 2 X 1/4 Wear Ring NYL

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 2 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

WR-NYL, 2 3/4 X 3/8 Wear Ring

Parback® backup ring with a curved cross-section.

Parbaks are contoured on one face to minimize distortion of the o-ring when under pressure. Parbaks should be installed with the contoured face against the o-ring, but reversal does no harm.

90A Durometer | Buna-N Rubber Material | 5 3/4 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring

Features

• Excellent extrusion resistance
• Easily stretched for installation
• Lubrication is enhanced by rubber which absorbs system fluid and does not plate out on rubbing surfaces

Parback® backup ring with a curved cross-section.

Parbaks are contoured on one face to minimize distortion of the o-ring when under pressure. Parbaks should be installed with the contoured face against the o-ring, but reversal does no harm.

90A Durometer | Buna-N Rubber Material | 6 1/4 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring

Features

• Excellent extrusion resistance
• Easily stretched for installation
• Lubrication is enhanced by rubber which absorbs system fluid and does not plate out on rubbing surfaces

WR-NYL, 5 1/2 X 3/4 Wear Ring

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 8 3/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

Our 612F style flexible guide bearings, with a 1/8” radial thickness, offered in a boxed quantity. The strip can be cut to any length using anvil type pruning shears. Product length is 32’ per box.

Polyester Resin Material | 1/8 in Cross Section | Boxed Flexible Guide Bearing

Solid Urethane backup ring with a flat cross-section.

95A Durometer | Urethane Material | 2 5/8 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation