Wipers
Filter Your Search
Shop by Category
Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.
90A Durometer | Urethane Material | 2 in Nominal Inner Diameter
Features
- Slotted heel design
- Slots in the heel allow excess hydraulic fluid to bypass the wiper
AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.
AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.
- Flexible, snap-in design for easy installation into closed housings
- Low compression set
Utilizing a sturdy metal case, these wipers are molded from the same high performance urethane used in our Heavy Duty U-seals. Built for severe service, these wipers are capable of surviving hostile environments.
92A Durometer | Urethane Material | 5 1/2 in Nominal Inner Diameter
Features
- Used in Heavy Duty U-seals
- Capable of surviving hostile environments
- Molded from the high performance urethane
Molded in urethane, this wiper is flexible enough to easily snap into a groove yet tough enough to handle difficult rod wiping applications.
Urethane Material | 22 MM Inner Diameter | Wiper
Molded in urethane, this wiper features a double lip which prevents fluid that seeps by the rod seal from exiting the cylinder.
Urethane Material | 16 MM Inner Diameter | Wiper
Molded in urethane, this wiper features a double lip which prevents fluid that seeps by the rod seal from exiting the cylinder.
Urethane Material | 18 MM Inner Diameter | Wiper
Molded in urethane, this wiper features a double lip which prevents fluid that seeps by the rod seal from exiting the cylinder.
Urethane Material | 90 MM Inner Diameter | Wiper
This wiper features a lip on top of the shoulder which makes contact with the throat of the groove. This serves to prevent contaminants from entering the groove.
Urethane Material | 32 MM Inner Diameter | Wiper
The style MW38 wiper is made from tough abrasion resistant polyester based material for difficult conditions found in mining and earth moving applications. It incorporates a sealing lip on the outside diameter to prevent moisture entering the groove.
The Hallite 38 single-lipped polyester wiper/scraper is designed to fit metric housings including those of ISO 6195A. Suitable for heavy duty applications. The proportions of the wiping lip ensure that contact is maintained with the surface of the rod to remove heavily deposited containments such as mud and ice.
55D Durometer | Polyester Material | 100 MM Inner Diameter | Wiper
Features
- Crush lip design provides effective seal on housing
- Ribs relieve pressure and improve stability
- Effective scraping lip to scrape off heavily deposited containments including ice