Search Results

These lip-type buffer seals are designed for replacement in Caterpillar® cylinders. The hinged-lip design reduces friction, heat, and wear under low-pressure conditions and acts as a check valve allowing back-pressure relief. Seals for rod sizes 2-1/8” and under do not have a back-up ring.

Urethane Material | 1 1/2 in Nominal Inner Diameter | Buffer Seal

These lip-type buffer seals are designed for replacement in Caterpillar® cylinders. The hinged-lip design reduces friction, heat, and wear under low-pressure conditions and acts as a check valve allowing back-pressure relief. Seals for rod sizes 2-1/8” and under do not have a back-up ring.

Urethane Material | 2 3/4 in Nominal Inner Diameter | Buffer Seal

Used interchangeably for piston or rod sealing, these u-seals employ the same tough urethane material found in our, Heavy Duty Rod and Piston U-Seals.

92A Durometer | Urethane Material | 2 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

0.5 in clevis pin with 0.041 in grooves machined into each end to fit two retaining rings. Retaining rings are not included.

Pivot pins with grooves are meant to be used on a hydraulic cylinder that extends and retracts a telescoping lift arm.

Specifically designed as piston seals, these u-seals are engineered to seal on their outside diameter. They offer extended, service life and maximum reliability in piston sealing.

92A Durometer | Urethane Material | 2 1/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal

Specifically designed as piston seals, these u-seals are engineered to seal on their outside diameter. They offer extended, service life and maximum reliability in piston sealing.

92A Durometer | Urethane Material | 2 3/4 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

Used interchangeably for piston or rod sealing, these u-seals employ the same tough urethane material found in our, Heavy Duty Rod and Piston U-Seals.

92A Durometer | Urethane Material | 2 3/4 in Nominal Inner Diameter | 3/8 in Cross Section | U-Seal

Threaded at the base with a pin hole inside of the spherical bearing. Order to fit piston rod thread size.

Threaded at the base with a pin hole inside of the spherical bearing. Order to fit piston rod thread size.

Threaded at the base with a pin hole inside of the spherical bearing. Order to fit piston rod thread size.