Search Results
Filter Your Search
Category Group
Shop by Category
8 1/4 X 8 1/2 Back-up SOLID PTFE
Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.
Nylon Material | 3 1/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring
Features
- Protection Against Wear
- Reduced Friction
- Extended Cylinder Life
- Operational Efficiency
Solid Urethane backup ring with a flat cross-section.
95A Durometer | Urethane Material | 5 5/8 in Nominal Inner Diameter | 3/16 in Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
WR-NYL, 4 X 3/4 Wear Ring
17 1/2 X 18 Back-up SOLID PTFE
Used primarily as an anti-extrusion device for u-seals, these back-up rings combine high performance with very low friction. “ST” suffix designates a split ring.
PTFE Material | 1 3/8 in Nominal Inner Diameter | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
660-5000X7000 has a 1 in thick wall. The ID is 5 in and the OD is 7 in. The material is 660 Bronze Copper Alloy 932.
- Long life span
- Machinability rating of 70
- Not subject to dezincification
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
| 1-4 | $107.31 |
| 5-9 | $95.29 |
| 10-14 | $85.85 |
| 15+ | $78.12 |
ALUM-10130 has a 10.13 in diameter. The material is 6061 Aluminum T6
6061 Aluminum T6 is suitable for machining pistons and head glands.
The T6 refers to the temper or degree of hardness. T6 has been solution heat treated and artificially aged to provide the maximum yield strength for a 6061 aluminum alloy.
- Heat treated and aged for increased strength
- Easily formed
- Weldable
- Corrosion resistant
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
| 1-14 | $59.54 |
| 15-29 | $53.64 |
| 30+ | $48.81 |
AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems. Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.
90A Durometer | Urethane Material | 1 5/8 in Nominal Inner Diameter
Features
- Flexible, snap-in design for easy installation into closed housings
- Low compression set
