Wipers

This wiper is molded from high grade urethane and bonded to a carbon steel case in a single lip design.

Urethane Material | 90 MM Nominal Inner Diameter | Wiper

This wiper is a single lip design molded from high grade urethane and bonded to a carbon steel case.

Urethane Material | 60 MM Nominal Inner Diameter | Wiper

Molded in urethane, this wiper features a double lip which prevents fluid that seeps by the rod seal from exiting the cylinder.

Urethane Material | 55 MM Inner Diameter | Wiper

Style ST-XL-PM wipers are molded from 55D polyester and are direct replacements for Style “ST”, “ST-XL” or “D” wipers. The polyester based material provides a tough abrasion resistant wiper for heavy contaminant environments. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

55D Durometer | Polyester Material | 2 in Nominal Inner Diameter

Features

• Molded from 55D polyester
• The outside diameter of the ring has a crush lip providing extra interference in the groove
• The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal

Style ST wiper rings are precision molded from 90A durometer urethane. Flexible enough to easily snap into a groove yet tough enough to handle difficult rod wiping applications. “V” tagged wipers are constructed of fluorocarbon.

90A Durometer | Fluorocarbon Material | 2 in Nominal Inner Diameter

Features

• Flexible enough to snap into a groove
• Wipers are constructed of fluorocarbon

AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.

AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.

• Flexible, snap-in design for easy installation into closed housings
• Low compression set

Molded in nitrile with a steel case, this seal is double cased and used to exclude contaminants from cylinder link pins.

Urethane Material | 90 MM Nominal Inner Diameter | Dust Seal

Wipers are installed in hydraulic cylinders to prevent dirt, dust, and moisture from entering the cylinder as they retract back into the system. A hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components.

90A Durometer | Urethane Material | 1 1/4 in Nominal Inner Diameter

Features

• Installed in hydraulic cylinders to prevent dirt, dust, and moistures
• Hydraulic wiper prevents contamination that could damage wear rings, seals, and other cylinder components

AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems. Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.

90A Durometer | Urethane Material | 15/16 in Nominal Inner Diameter

Features

• Flexible, snap-in design for easy installation into closed housings
• Low compression set

AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems. Suffix “SH” designates slotted heel design, “V” designates fluorocarbon material, and “B” designates carboxilated nitrile material.

90A Durometer | Fluorocarbon Material | 1 in Nominal Inner Diameter

Features

• Flexible, snap-in design for easy installation into closed housings
• Low compression set