Search Results

TSS, 3-1/4 X 3/4 Wear Ring CT

Specifically designed as piston seals, these u-seals are engineered to seal on their outside diameter. They offer extended, service life and maximum reliability in piston sealing.

92A Durometer | Urethane Material | 1 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

HC-7750-8 has a 9 in OD and is made to fit a 7 in bore cylinder.

Head cap size is determined based on the bending stress.

A static seal or o-ring is used in between the head cap and barrel (except welded construction).

The main function of the head cap is to enclose the pressure chamber at one end. The cap is connected to the cylinder body by means of welding, threading, bolts, or tie rod.

Designed to fit a 3.5 in inch cylinder bore and 1.5 in inch rod.

The gland is not threaded. It is held in place by a cylinder head cap and corresponding seal kit.

These seals are specifically designed to seal on their inside diameter and engineered to attain maximum life and reliability in dynamic rod sealing.

92A Durometer | Urethane Material | 7 in Nominal Inner Diameter | 1/2 in Cross Section | U-Seal

HS-TFE-4.403odX0.143htX0.065cs

Molded in 90A urethane, this seal was developed to be used as a head seal and to replace an o-ring and a back-up. Its symmetrical one-piece design reduces the risk of installation damage and back-up blow-out.

90A Durometer | Urethane Material | 4 1/2 in Nominal Inner Diameter | 1/8 in Cross Section | Head Seal

O-rings as elastic loops that seal static and dynamic applications. They are used to seal the space between cylinders, pistons, pipes and tubes and can be made from various materials.

70A Durometer | Nitrile Material | 26 MM Nominal Inner Diameter | 2 MM Cross Section | O-Ring

Features

• Chemical resistance
• Temperature range of -40 °F to 220 °F

This wiper is a single lip design molded from high grade urethane and bonded to a carbon steel case.

Urethane Material | 80 MM Nominal Inner Diameter | Wiper

O-rings as elastic loops that seal static and dynamic applications. They are used to seal the space between cylinders, pistons, pipes and tubes and can be made from various materials.

70A Durometer | Nitrile Material | 31 MM Nominal Inner Diameter | 2.5 MM Cross Section | O-Ring

Features

• Chemical resistance
• Temperature range of -40 °F to 220 °F