Search Results
Filter Your Search
Category Group
Shop by Category
Molded in a tough urethane, this rod u-seal fits tightly in the groove while providing increased radial force on the rod.
Urethane Material | 56 MM Nominal Inner Diameter | Rod U-Seal
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 30 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
The Hallite 533 is capable of withstanding high side loads and preventing metal-to-metal contact between the piston and the bore or the rod and the gland.
The PA 533 material is heat stabilised 33% glass reinforced nylon 66, which offers excellent bearing properties.
Compatible with hydraulic and lubricating oils. The PA 533 material is not recommended for use in water based fluids (HFA) or where significant water is present, due to the swell of the nylon.
US-90NBR-1-5/8×2×3/16
140mm induction hardened chrome shafting.
The base material is 1045/1050 Carbon Steel with 0.0005 in (0.0127mm minimum)-thick chrome plating and a case depth of 0.05 in (1.27 mm).
Induction Hardened Chrome is typically used in abrasive envrionments where the cylinder is exposed to rocks or heavy debris. Also used to machine clevis pins.
- Greater strength
- Better resistance to mechanical damage
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
| 1-14 | $65.71 |
| 15-29 | $46.98 |
| 30-59 | $41.07 |
| 60-119 | $32.85 |
| 120+ | $29.90 |
JIC 1500X120 has a 1.5 in in OD and a 0.12 in in thick wall.
JIC tubing is sold in 20 ft. lengths only. Tubes can be cut for UPS shipment or left whole, if necessary. Freight charges may vary depending on required length.
Cold drawn and annealed seamless low carbon steel. This tubing is intended for use as hydraulic lines and in other applications requiring flaring and bending.
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
JIC 500X049 has a 0.5 in in OD and a 0.049 in in thick wall.
JIC tubing is sold in 20 ft. lengths only. Tubes can be cut for UPS shipment or left whole, if necessary. Freight charges may vary depending on required length.
Cold drawn and annealed seamless low carbon steel. This tubing is intended for use as hydraulic lines and in other applications requiring flaring and bending.
Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.
