Search Results

The PS1800 provides low friction, high strength piston sealing. The PS1800 also provides double-acting piston sealing in a compact design that meets the requirements of ANSI/B93-32-1973. Piston diameter “I” dimensions are given for pistons without wear rings.

15% Glass Filled PTFE Material | 3 3/16 in Nominal Inner Diameter | Piston Seal

Features

• Easy assembly
• Low friction capabilities

Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

94A Durometer | Urethane Material | 10 in Nominal Inner Diameter

Features

• Crush lip to provide extra interference
• Bead on the shoulder to keep contaminants out
• Ribbed ID to prevent pressure traps

Single-lipped, snap-in rod wiper is designed to fit D-style housings.

The ST-XLF wipers are designed to fit the standard ST wiper groove. These wipers include a dust lip to prevent contaminates from entering through the groove. They also have a ribbed inside diameter for low friction operation and to prevent pressure traps between the wiper and rod seal. Developed specifically for use in harsher environments with heavy contamination, such as in agriculture, off-highway, and forestry equipment.

Urethane Material | 4 in Nominal Inner Diameter

Features

• Precision trimmed wiping lip
• Retrofits most ‘D’ wiper housings
• Especially effective in vertically mounted cylinders
• Designed to follow the rod deflection caused by side loads
• Interchangeable with Hallite 520 wiper
• Sharp wiping lip scrapes heavy contamination from rod protecting sealing system
• Umbrella Wiper Technology™ protects housing from contamination and reduces moisture ingress

US-90URE-3-1/2×4×1/4

US-90URE-7-1/4×8×1/2

T-Seals combine a resilient sealing ring with a hard, split back-up ring on each side of the sealing element. The assembly installs in a standard o-ring groove. T-Seals are non-spiraling and extrusion resistant to 5,000 psi with improved tolerances. Intermediate and Wide Base T-Seals are designed to fit MIL-5514F o-ring glands only and interchange with 1 o-ring / 1 back-up ring and 1 o-ring / 2 back-up ring grooves, respectively.

Buna-N Rubber Material | 1 1/4 in Nominal Inner Diameter | Piston T-Seal

US-90URE-1×1-1/4×3/16

US-90URE-1-1/4×1-1/2×1/8

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 6 3/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Scarf Cut wear ring
• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 7 1/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency