Search Results

CPOD5000X4000 has a wall thickness of 0.5 in. The ID is 4 in and the OD is 5 in. The material is 1026 Carbon Steel with chrome plating on the Outside Surface.

Full mill lengths will be cut to lengths between 12 ft and 19 ft long. Packages longer than 44 inches may have additional freight charges.

A heavy duty double-acting assembly, the capped piston T-seal exhibits excellent sealability, extrusion resistance, and wearability. T-seals with “BR” suffix utilize a Bronze Filled PTFE cap instead of the standard Glass Filled PTFE cap.

PTFE; Nylon; Rubber Material | 10.275 in Nominal Inner Diameter | Capped Piston T-Seal

Features

• Glass-filled PTFE cap, nylon back-up, rubber energizer

A heavy duty double-acting assembly, the capped piston T-seal exhibits excellent sealability, extrusion resistance, and wearability. T-seals with “BR” suffix utilize a Bronze Filled PTFE cap instead of the standard Glass Filled PTFE cap.

PTFE; Nylon; Rubber Material | 2.126 in Nominal Inner Diameter | Capped Piston T-Seal

Features

• Glass-filled PTFE cap, nylon back-up, rubber energizer

These lip-type buffer seals are designed for replacement in Caterpillar® cylinders. The hinged-lip design reduces friction, heat, and wear under low-pressure conditions and acts as a check valve allowing back-pressure relief. Seals for rod sizes 2-1/8” and under do not have a back-up ring.

Urethane Material | 2 in Nominal Inner Diameter | Buffer Seal

Specifically designed as piston seals, these u-seals are engineered to seal on their outside diameter. They offer extended, service life and maximum reliability in piston sealing.

92A Durometer | Urethane Material | 5 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

These seals are specifically designed with a second lip on their inside diameter and engineered to attain maximum, life and reliability in dynamic rod sealing. This feature results in reduced leakage, less friction, increased stability, and, prevents air and contaminants from entering the cylinder.

92A Durometer | Urethane Material | 2 3/4 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

Features

• General purpose rod seal
• Robust design
• Excellent wear resistance
• Increase seal stability
• Performs well over wide temperature range and is extremely effective in low temperatures
• Primary lip protection
• Easy to install

Used interchangeably for piston or rod sealing, these u-seals employ the same tough urethane material found in our, Heavy Duty Rod and Piston U-Seals.

92A Durometer | Urethane Material | 3 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal

Molded in PTFE with a rubber energizer, this seal absorbs the shock of pressure spikes to protect the rod seal. Bronze-filled Teflon rod buffer seal with a rubber energizer.

Bronze Filled PTFE Material | 1 1/2 in Nominal Inner Diameter | Buffer Seal

92A Durometer | Urethane Material | 2 1/2 in Nominal Inner Diameter | Wiper

92A Durometer | Urethane Material | 2 1/2 in Nominal Inner Diameter | Wiper

Commonly used with metric o-rings, these back-up rings are made of virgin PTFE unless suffix specifies otherwise.

PTFE Material | 44 MM Nominal Inner Diameter | 3 MM Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation