Search Results
Filter Your Search
Category Group
Shop by Category
WR-NYL, 5 1/4 X 3/4 Wear Ring
6.000 X 5.274 X 750 Capped T BFT
Molded in PTFE with a rubber energizer, this seal absorbs the shock of pressure spikes to protect the rod seal.
70A Durometer | Filled PTFE Buffer Material | 110 MM Nominal Inner Diameter | Buffer Seal
Totally interchangeable with Style PS1400 PTFE piston seals, Style PS1500 piston seals are molded from tough 60 Shore D durometer polyurethane. During the molding process, a .002” thick band of molybdenum disulfide is molded into the outside diameter of the seal ring for reduced friction. PS1500 piston seals are easily stretched over the piston and recover rapidly with the elimination of the “cold flow” characteristics found in PTFE seals. Piston diameter “I” dimensions are given for pistons without wear rings.
60 Shore D Durometer | Polyurethane Material | 2.356 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
This two piece piston seal design comes made with a heat-stabilized, thermoplastic step-cut ring along with a profiled NBR energizer. This product offers extreme strength and resistance to extrusion, a very high resistance to abrasion, and ease of installation thanks to the step cut design and chamfered edges. The design also allows the seal to pass over ports without damage and offers greater resistance to surface roughness in comparison to any elastomer seals. The profiled energizer offers improved dynamic sealing ability, responding quickly to pressure changes and providing excellent sealing characteristics under a wide range of pressure conditions.
Glass Filled Nylon Material | 4.74 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.
94A Durometer | Urethane Material | 3 1/4 in Nominal Inner Diameter
Features
- Crush lip to provide extra interference
- Bead on the shoulder to keep contaminants out
- Ribbed ID to prevent pressure traps
Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.
Nylon Material | 2 3/4 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring
Features
- Protection Against Wear
- Reduced Friction
- Extended Cylinder Life
- Operational Efficiency
Style HRU u-seals are precision molded from 80 Durometer Buna-N rubber. Sizes include those found in Army-Navy spec. AN6226 and narrow cross-section sizes found in J.I.C. cylinders and the popularly termed “Huva Cup”.
80A Durometer | Buna-N Rubber Material | 1 1/2 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
Style HRU u-seals are precision molded from 80 Durometer Buna-N rubber. Sizes include those found in Army-Navy spec. AN6226 and narrow cross-section sizes found in J.I.C. cylinders and the popularly termed “Huva Cup”.
80A Durometer | Buna-N Rubber Material | 2 3/4 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
