Search Results
Filter Your Search
Category Group
Shop by Category
Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.
94A Durometer | Urethane Material | 3 3/4 in Nominal Inner Diameter
Features
- Crush lip to provide extra interference
- Bead on the shoulder to keep contaminants out
- Ribbed ID to prevent pressure traps
Molded in PTFE with a rubber energizer, this seal absorbs the shock of pressure spikes to protect the rod seal.
70A Durometer | Filled PTFE Buffer Material | 100 MM Nominal Inner Diameter | Buffer Seal
Molded from filled PTFE and machined to close tolerances, these seals feature low friction and excellent wear characteristics. Nitrile rings are used for energizers.
70A Durometer | PTFE Material | 66 MM Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Molded from tough, wear resistant 55D polyester, these seals are for light to medium duty applications and are interchangeable with the style MPS seals of the same dimensions. Nitrile rings are used for energizers.
55D; 70A Durometer | Polyester Material | 52 MM Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 25 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 35 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
Molded in a tough urethane, this seal employs an additional lip near the heel. The twin lip design provides stability, friction-reducing lube retention, and some contaminant resistance. VME – Secondary lip is further from heel than standard MRTU. NOTE: E = European Urethane.
Urethane Material | 40 MM Nominal Inner Diameter | Rod U-Seal
Features
- Excellent low temperature performance
- Easy installation
Fabricated from fine woven fabric and phenolic resins, this wear ring is strong yet light weight with an excellent wear rate.
Phenolic Material | 58 MM Nominal Inner Diameter | Wear Ring
Features
- Protection Against Wear
- Reduced Friction
- Extended Cylinder Life
- Operational Efficiency
Style 850 u-seals offer excellent resistance to extrusion and abrasion. The round cross-section expander offers energized sealing from zero to 5,000 psi.
95A Durometer | Urethane Material | 7/8 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
