U-seals, Polypaks, U-cups
Search in Category
Filter Your Search
Category Group
Durometer
Material
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.
90A Durometer | Urethane Material | 2 1/4 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.
90A Durometer | Urethane Material | 3 5/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
Our Style 800 orange Hytrel U-seals offer superior resistance to abrasion, extrusion, and heat. As a drop-in replacement, for our standard Style 800 U-seals, they can prolong equipment life under today’s increased demands. These seals are, suitable for both petroleum-based and water-based fluids.
55D Durometer | Hytrel Material | 1 3/8 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.
90A Durometer | Urethane Material | 3 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 1 1/2 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 5/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
