U-seals, Polypaks, U-cups
Search in Category
Filter Your Search
Category Group
Durometer
Material
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 4 in Nominal Inner Diameter | 1/2 in Cross Section | U-Seal
UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.
90A Durometer | Urethane Material | 2 13/16 in Nominal Inner Diameter | 7/32 in Cross Section | U-Seal
Style PU seals are molded from high quality urethane and designed specifically for piston applications.
90A Durometer | Urethane Material | 1 3/16 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 1 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
