Search Results

Machined from 1018 Carbon Steel for a 2 in cylinder.

The length is 0.5 in and the lip is 0.25 in in tall.

Base plates are welded to the end of the cylinder opposite the rod end to secure the cylinder. They provide a solid support for the entire cylinder base area.

1 9/16 X 1 3/4 Back-up SOLID PTFE

Solid Teflon backup ring with a flat cross-section.

PTFE can withstand high temperatures and is compatible with nearly all fluids.

PTFE Material | 1 13/16 in Nominal Inner Diameter | 3/32 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation
• Deals very well with surface wear

Wear rings provide a hard-wearing surface that protects the cylinder walls and the piston rod from scoring and abrasion. By maintaining alignment and reducing side loads, these rings facilitate smoother piston movement and lower friction levels.

Nylon Material | 7 in Nominal Inner Diameter | 1/8 in Cross Section | Wear Ring

Features

• Scarf Cut wear ring
• Protection Against Wear
• Reduced Friction
• Extended Cylinder Life
• Operational Efficiency

CPLUG-NYL-800X910X75(10)

CPLUG-NYL-1.175X1.284X(25)

CPLUG-NYL-1/4X3/8 (50)

CPLUG-NYL-.64X.727X.5(130

GB-PHEN-1×1/8-C/S

Solid Urethane backup ring with a flat cross-section.

95A Durometer | Urethane Material | 3 5/8 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring

Features

• High strength and abrasion resistance
• Wide temperature range
• Chemical resistance
• Low friction
• Easy installation