Mobile Equipment Seal Kits
Search in Category
Filter Your Search
Category Group
Durometer
Material
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
Specifically designed as piston seals, these u-seals are engineered to seal on their outside diameter. They offer extended, service life and maximum reliability in piston sealing.
92A Durometer | Urethane Material | 4 1/4 in Nominal Inner Diameter | 3/8 in Cross Section | U-Seal
Molded in a tough urethane, this rod u-seal fits tightly in the groove while providing increased radial force on the rod.
Urethane Material | 75 MM Nominal Inner Diameter | Rod U-Seal
Utilizing tough polyurethane, these seals possess excellent wear and abrasion resistance. Symmetrical in design, they can be used in rod or piston applications. E= European Urethane.
Urethane Material | 60 MM Nominal Inner Diameter | U-Seal
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 4 1/4 in Nominal Inner Diameter | 3/8 in Cross Section | U-Seal
Molded from high quality urethane, the MPU is designed specifically for piston applications.
Urethane Material | 50 MM Nominal Inner Diameter | Piston Seal
5/8 Rod Kits
Style 850 u-seals offer excellent resistance to extrusion and abrasion. The round cross-section expander offers energized sealing from zero to 5,000 psi.
95A Durometer | Urethane Material | 1 1/2 in Nominal Inner Diameter | 1/8 in Cross Section | U-Seal
UKP u-seals are designed to act as a positive sealing, low friction replacement for conventional rubber u-seals. Molded, from polyurethane, UKP u-seals provide long life and high resistance against extrusion. Low friction allows these seals, to run smoothly in a lubricated or non-lubricated cylinder. Available for bore sealing, the flexible dynamic lip provides, very low breakaway friction and steady motion.
90A Durometer | Urethane Material | 1 3/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
