Mobile Equipment Seal Kits
Search in Category
Filter Your Search
Category Group
Durometer
Material
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
Our Style 800 orange Hytrel U-seals offer superior resistance to abrasion, extrusion, and heat. As a drop-in replacement, for our standard Style 800 U-seals, they can prolong equipment life under today’s increased demands. These seals are, suitable for both petroleum-based and water-based fluids.
55D Durometer | Hytrel Material | 2 1/8 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
The Z-Seal™ is a squeeze type seal, combining the excellent sealability and low compression set of a resilient rubber lip with the greater anti-extrusion characteristics of a hard thermoplastic base. Under low pressure conditions, the sealing lip provides its own compressive seal force. As pressure increases, hydrostatic pressure is mechanically transmitted through the elastomeric seal element into the anti-extrusion base. The applied force then deflects radially in a controlled manner, closing the extrusion gap behind the sealing lip. Under this condition, maximum sealing effectiveness is achieved.
95A 70A Durometer | Urethane Nitrile Rubber Material | 2 1/4 in Nominal Inner Diameter | 1/4 in Cross Section | Z-Seal
Style 800 U-seals are molded from tough, abrasion-resistant polyurethane. The four lobed expander ring energizes the, sealing lips, even at zero pressure, to help prevent “weeping” when the system is idle.
95A Durometer | Urethane Material | 2 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
The Z-Seal™ is a squeeze type seal, combining the excellent sealability and low compression set of a resilient rubber lip with the greater anti-extrusion characteristics of a hard thermoplastic base. Under low pressure conditions, the sealing lip provides its own compressive seal force. As pressure increases, hydrostatic pressure is mechanically transmitted through the elastomeric seal element into the anti-extrusion base. The applied force then deflects radially in a controlled manner, closing the extrusion gap behind the sealing lip. Under this condition, maximum sealing effectiveness is achieved.
95A 70A Durometer | Urethane Nitrile Rubber Material | 2 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | Z-Seal
Our Style 800 orange Hytrel U-seals offer superior resistance to abrasion, extrusion, and heat. As a drop-in replacement, for our standard Style 800 U-seals, they can prolong equipment life under today’s increased demands. These seals are, suitable for both petroleum-based and water-based fluids.
55D Durometer | Hytrel Material | 2 1/2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
The Z-Seal™ is a squeeze type seal, combining the excellent sealability and low compression set of a resilient rubber lip with the greater anti-extrusion characteristics of a hard thermoplastic base. Under low pressure conditions, the sealing lip provides its own compressive seal force. As pressure increases, hydrostatic pressure is mechanically transmitted through the elastomeric seal element into the anti-extrusion base. The applied force then deflects radially in a controlled manner, closing the extrusion gap behind the sealing lip. Under this condition, maximum sealing effectiveness is achieved.
95A 70A Durometer | Urethane Nitrile Rubber Material | 2 5/8 in Nominal Inner Diameter | 1/4 in Cross Section | Z-Seal
