U-seals, Polypaks, U-cups
Search in Category
Filter Your Search
Category Group
Durometer
Material
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Style
Unit of Measure
Shop by Category
Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.
95A Durometer | Fluorocarbon Material | 2 1/2 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
The Z-Seal™ is a squeeze type seal, combining the excellent sealability and low compression set of a resilient rubber lip with the greater anti-extrusion characteristics of a hard thermoplastic base. Under low pressure conditions, the sealing lip provides its own compressive seal force. As pressure increases, hydrostatic pressure is mechanically transmitted through the elastomeric seal element into the anti-extrusion base. The applied force then deflects radially in a controlled manner, closing the extrusion gap behind the sealing lip. Under this condition, maximum sealing effectiveness is achieved.
95A 70A Durometer | Urethane Nitrile Rubber Material | 6 in Nominal Inner Diameter | 3/8 in Cross Section | Z-Seal
These seals are specifically designed to seal on their inside diameter and engineered to attain maximum life and reliability in dynamic rod sealing.
92A Durometer | Urethane Material | 5 1/4 in Nominal Inner Diameter | 3/8 in Cross Section | U-Seal
Style DSU-BHT symmetrical seals are molded in Freudenberg® AU 30000 urethane. Used interchangeably for piston, or rod sealing. This high tear-resistant urethane demonstrates stability throughout a wide range of temperatures., In addition, this material is well suited to mineral and biodegradable hydraulic fluids as well as being resistant to, hydrolysis.
Urethane Material | 1 3/4 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
Style HRU u-seals are precision molded from 80 Durometer Buna-N rubber. Sizes include those found in Army-Navy spec. AN6226 and narrow cross-section sizes found in J.I.C. cylinders and the popularly termed “Huva Cup”.
90A Durometer | Fluorocarbon Material | 2 1/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal
Style HRU u-seals are precision molded from 80 Durometer Buna-N rubber. Sizes include those found in Army-Navy spec. AN6226 and narrow cross-section sizes found in J.I.C. cylinders and the popularly termed “Huva Cup”.
80A Durometer | Buna-N Rubber Material | 3 in Nominal Inner Diameter | 7/32 in Cross Section | U-Seal
Style HRU u-seals are precision molded from 80 Durometer Buna-N rubber. Sizes include those found in Army-Navy spec. AN6226 and narrow cross-section sizes found in J.I.C. cylinders and the popularly termed “Huva Cup”.
80A Durometer | Buna-N Rubber Material | 2 in Nominal Inner Diameter | 1/4 in Cross Section | U-Seal
