U-seals, Polypaks, U-cups

US-95URE/NBR-7/8×1-1/4×3/16

Style 800 U-seals are molded from tough, abrasion-resistant polyurethane. The four lobed expander ring energizes the, sealing lips, even at zero pressure, to help prevent “weeping” when the system is idle.

95A Durometer | Urethane Material | 7/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal

US-90URE-7/8×1-1/4×3/16

US-90URE-15/16×1-5/16×3/16

US-95URE/NBR-1×1-3/8×3/16

Style 800 U-seals are molded from tough, abrasion-resistant polyurethane. The four lobed expander ring energizes the, sealing lips, even at zero pressure, to help prevent “weeping” when the system is idle.

95A Durometer | Urethane Material | 1 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal

Utilizing the same profiles as the Style 800 Polyurethane U-Seal line, these u-seals are molded from a fluorocarbon, compound. While being compatible with a broader range of fluids, these fluorocarbon seals will also operate, continuously at temperatures from -20° to +400 °F. NOTE: If you are not sure of fluid/seal compatibility, please refer, to the fluid compatibility chart in the appendix or contact our Engineering Department.

95A Durometer | Fluorocarbon Material | 1 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal

US-90URE-1-1/8×1-1/2×1/4

Style 800 U-seals are molded from tough, abrasion-resistant polyurethane. The four lobed expander ring energizes the, sealing lips, even at zero pressure, to help prevent “weeping” when the system is idle.

95A Durometer | Urethane Material | 1 1/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal

Our Style 800 orange Hytrel U-seals offer superior resistance to abrasion, extrusion, and heat. As a drop-in replacement, for our standard Style 800 U-seals, they can prolong equipment life under today’s increased demands. These seals are, suitable for both petroleum-based and water-based fluids.

55D Durometer | Hytrel Material | 1 1/8 in Nominal Inner Diameter | 3/16 in Cross Section | U-Seal