Backup Rings
Search in Category
Filter Your Search
Category Group
Material
Nominal Cross Section
Nominal Height
Nominal Inner Diameter
Nominal Outer Diameter
Unit of Measure
Shop by Category
Commonly used with metric o-rings, these back-up rings are made of virgin PTFE unless suffix specifies otherwise.
PTFE Material | 56 MM Nominal Inner Diameter | 5 MM Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Commonly used with metric o-rings, these back-up rings are made of virgin PTFE unless suffix specifies otherwise.
PTFE Material | 5 MM Nominal Inner Diameter | 1.5 MM Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Commonly used with metric o-rings, these back-up rings are made of virgin PTFE unless suffix specifies otherwise.
PTFE Material | 62 MM Nominal Inner Diameter | 2.5 MM Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
MBU, 71 X 5 X 3 Metric B/U PTFE
Commonly used with metric o-rings, these back-up rings are made of virgin PTFE unless suffix specifies otherwise.
PTFE Material | 7 MM Nominal Inner Diameter | 1.5 MM Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Hytrel backup ring with a flat cross-section.
Molded of 55D Durometer Hytrel, these back-up rings provide excellent extrusion resistance and tolerance to fluids such as phosphate esters, hydraulic oil and water. Stretched for installation, they return quickly to their original size for easy installation.
55D Durometer | Hytrel Material | 9/16 in Nominal Inner Diameter | 0.11 in Cross Section | Backup Ring
Features
- Improved extrusion resistance compared to standard FKM or NBR backups
- Can be stretched over larger diameters and will return quickly to their original size
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Parback® backup ring with a curved cross-section.
Parbaks are contoured on one face to minimize distortion of the o-ring when under pressure. Parbaks should be installed with the contoured face against the o-ring, but reversal does no harm.
90A Durometer | Buna-N Rubber Material | 1/8 in Nominal Inner Diameter | 3/32 in Cross Section | Backup Ring
Features
- Excellent extrusion resistance
- Easily stretched for installation
- Lubrication is enhanced by rubber which absorbs system fluid and does not plate out on rubbing surfaces
Split Nylon backup ring with a flat cross-section.
Nylon Material | 2 7/8 in Nominal Inner Diameter | 1/4 in Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Hard nylon back-up rings for use with U-seals.
Nylon Material | 50 MM Nominal Inner Diameter | 5 MM Cross Section | U-Seal Back-Up Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
Solid Urethane backup ring with a flat cross-section.
95A Durometer | Urethane Material | 6 1/4 in Nominal Inner Diameter | 1/8 in Cross Section | Backup Ring
Features
- High strength and abrasion resistance
- Wide temperature range
- Chemical resistance
- Low friction
- Easy installation
