Snap-in Wipers for Sale | CRC Distribution
Search in Category
Filter Your Search
Category Group
Material
Nominal Inner Diameter
Nominal Outer Diameter
Unit of Measure
Shop by Category
The style MW38 wiper is made from tough abrasion resistant polyester based material for difficult conditions found in mining and earth moving applications. It incorporates a sealing lip on the outside diameter to prevent moisture entering the groove.
55D Durometer | Polyester Material | 75 MM Inner Diameter | Wiper
The style MW38 wiper is made from tough abrasion resistant polyester based material for difficult conditions found in mining and earth moving applications. It incorporates a sealing lip on the outside diameter to prevent moisture entering the groove.
55D Durometer | Polyester Material | 60 MM Inner Diameter | Wiper
Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.
94A Durometer | Urethane Material | 12 in Nominal Inner Diameter
Features
- Crush lip to provide extra interference
- Bead on the shoulder to keep contaminants out
- Ribbed ID to prevent pressure traps
The ST-XLFT was developed for hard environments, particularly longwall mining. These wipers include a dust lip to prevent contaminates from entering through the groove. They also have a ribbed inside diameter for low friction operation and to prevent pressure traps between the wiper and rod seal.
93A Durometer | Urethane Material | 3 5/8 in Nominal Inner Diameter
Features
- Include a dust lip to prevent contaminates from entering through the groove
- Ribbed inside diameter for low friction operation
- Prevent pressure traps between the wiper and rod seal
Single-lipped, snap-in rod wiper is designed to fit D-style housings.
The ST-XLF wipers are designed to fit the standard ST wiper groove. These wipers include a dust lip to prevent contaminates from entering through the groove. They also have a ribbed inside diameter for low friction operation and to prevent pressure traps between the wiper and rod seal. Developed specifically for use in harsher environments with heavy contamination, such as in agriculture, off-highway, and forestry equipment.
Urethane Material | 5 in Nominal Inner Diameter
Features
- Precision trimmed wiping lip
- Retrofits most ‘D’ wiper housings
- Especially effective in vertically mounted cylinders
- Designed to follow the rod deflection caused by side loads
- Interchangeable with Hallite 520 wiper
- Sharp wiping lip scrapes heavy contamination from rod protecting sealing system
- Umbrella Wiper Technology™ protects housing from contamination and reduces moisture ingress
Style ST-XL wipers are molded from premium urethane and are direct replacements for Style “ST” or “D” wipers. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.
94A Durometer | Urethane Material | 4 1/2 in Nominal Inner Diameter
Features
- Crush lip to provide extra interference
- Bead on the shoulder to keep contaminants out
- Ribbed ID to prevent pressure traps
AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.
AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.
- Flexible, snap-in design for easy installation into closed housings
- Low compression set
