Wipers

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 35 MM Inner Diameter | Wiper

RW-95URE-10.000×11.000×0.500

15 X 16 X 1/2 D Wiper

Style ST wiper rings are precision molded from 90A durometer urethane. Flexible enough to easily snap into a groove yet tough enough to handle difficult rod wiping applications. “V” tagged wipers are constructed of fluorocarbon.

90A Durometer | Fluorocarbon Material | 3 1/2 in Nominal Inner Diameter

Features

• Flexible enough to snap into a groove
• Wipers are constructed of fluorocarbon

Style ST-XL-PM wipers are molded from 55D polyester and are direct replacements for Style “ST”, “ST-XL” or “D” wipers. The polyester based material provides a tough abrasion resistant wiper for heavy contaminant environments. The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

55D Durometer | Polyester Material | 4 in Nominal Inner Diameter

Features

• Molded from 55D polyester
• The outside diameter of the ring has a crush lip providing extra interference in the groove
• The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal

The Hallite 820 single-lipped, snap-in rod wiper is designed to fit North American D-style housings and has been developed specifically for use in harsher environments with heavy contamination, such as in agriculture, off-highway, and forestry equipment. These wipers include a dust lip to prevent contaminates from entering through the groove. They also have a ribbed inside diameter for low friction operation and to prevent pressure traps between the wiper and rod seal.

93A Durometer | Urethane Material | 4 in Nominal Inner Diameter

Features

• Umbrella Wiper Technology™
• Reducing corrosion and preventing the ingress of contamination into the wiper housing groove and hydraulic cylinder gland which will result in increased system life.
• Moulded ribs on the internal diameter
• Easy to install without the use of special tooling
• Normally specified for harsh environments

RW, 4-1/2 X 5-1/4 X 3/8 VITON D WIPER

Style ST wiper rings are precision molded from 90A durometer urethane. Flexible enough to easily snap into a groove yet tough enough to handle difficult rod wiping applications. “V” tagged wipers are constructed of fluorocarbon.

90A Durometer | Urethane Material | 4 3/4 in Nominal Inner Diameter

Features

• Flexible enough to snap into a groove
• Wipers are constructed of fluorocarbon

A wide range of ST wipers are now offered in the slotted heel design. The slots in the heel allow excess hydraulic fluid to bypass the wiper, preventing wiper blowout.

90A Durometer | Urethane Material | 4 3/4 in Nominal Inner Diameter

Features

• Slotted heel design
• Slots in the heel allow excess hydraulic fluid to bypass the wiper

RWD, 5.000 X 5.750 X 0.375 D Wiper FKM