Wipers

RW-55D URE-80.00×91.00×7.50

The style MW38 wiper is made from tough abrasion resistant polyester based material for difficult conditions found in mining and earth moving applications. It incorporates a sealing lip on the outside diameter to prevent moisture entering the groove.

55D Durometer | Polyester Material | 95 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 125 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 40 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 45 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 55 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 75 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 85 MM Inner Diameter | Wiper

Molded in nitrile, this double lipped wiper is common in Toyota lift trucks.

Nitrile Material | 95 MM Inner Diameter | Wiper

Each Seal Guard Wiper consists of two flexible bronze rings which are held in place by a nitrile cushion ring. The cushion ring absorbs side loads and energizes the wiper to maintain close contact with the rod. Particularly suited for hostile environments, seal guard wipers shave off sand, grift, slag, flux, paint, moisture, chips and slivers. Seal Guard Wipers are long-lasting, self-adjusting, and offer low friction. Seal Guard Wipers can be installed in standard Hercules® Sealing Products “ST” or “D” Style grooves by increasing the “F” gland dimension to the “F” Throat Diameter shown.

70A Durometer | 660 Bronze; Nitrile Material | 1/2 in Nominal Inner Diameter | Wiper