Piston Seals
Search in Category
Filter Your Search
Shop by Category
These specifically sized seals are for certain OEM cylinders (primarily Heil & Timberjack). Their use is intended for existing housings where the old seals are dimensionally comparable to the table below. Please call your sales representative if you need additional assistance.
Glass Filled PTFE Material | 3.738 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
6.000 X 5.240 X 0.375 Step Cut PS
Molded from a PTFE base material with 40% bronze and machined to exacting tolerances, this seal exhibits low friction and high strength corners are chamfered for cold flow resistance.
40% Bronze Filled PTFE Material | 2 5/16 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Molded from a PTFE base material with 40% bronze and machined to exacting tolerances, this seal exhibits low friction and high strength corners are chamfered for cold flow resistance.
40% Bronze Filled PTFE Material | 5 3/8 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Molded from a PTFE base material with 40% bronze and machined to exacting tolerances, this seal exhibits low friction and high strength corners are chamfered for cold flow resistance.
40% Bronze Filled PTFE Material | 6 21/32 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
5.750 X 4.925 X 0.319 TFB
This seal, molded from high grade 55D polyurethane, may retrofit the PS1800 seals, considering all dimensions are comparable. This seal material, with a high degree of memory, stretches over the piston and snaps in the groove for immediate assembly. These seals also feature low friction and high abrasion and extrusion resistance which helps to eliminate assembly damage. Piston diameter “I” dimensions are given for pistons without wear rings.
55D Durometer | Glass/PTFE Filled Polyurethane Material | 5.504 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
This seal, molded from high grade 55D polyurethane, may retrofit the PS1800 seals, considering all dimensions are comparable. This seal material, with a high degree of memory, stretches over the piston and snaps in the groove for immediate assembly. These seals also feature low friction and high abrasion and extrusion resistance which helps to eliminate assembly damage. Piston diameter “I” dimensions are given for pistons without wear rings.
55D Durometer | Glass/PTFE Filled Polyurethane Material | 6.504 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Piston diameter “I” dimensions are given for pistons without wear rings.
Glass Filled Nylon Material | 2.942 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities
Designed to fit on one or two piece pistons, this piston seal employs a nitrile seal for high sealability, nylon split backups for extrusion resistance, and two split bearing rings. No further support bearings are required.
90A Durometer | Nitrile Material | 2 5/8 in Nominal Inner Diameter | Piston Seal
Features
- Easy assembly
- Low friction capabilities